Welcome to the iPodRepairSquad.com iPod Nano Gen one disassembly manual. These models are tiny and fragile so make sure you use treatment once managing your unit.
Points You are going to Want
- Resources Necessary ? Soft Equipment - employed to open the scenario without having scratching. Accessible at www.ipodrepairsquad.com ? Little Phillips head screwdriver - #00
Opening the Situation
? Be certain the Maintain Change is turned on. You are going to see orange as soon as you have the Maintain in the appropriate placement.
? Making use of one soft device wedge it into the aspect of the iPod. It's favored to remain away from the Maintain Change and the headphone jack.
? Utilizing a aspect to facet movement, loosen the iPod whilst gently prying up and down. It's useful to insert two soft Resources at as soon as, Making use of 1 to Maintain the gap open and the other to slide.
? There are a number of clips keeping the scenario in place, so function your way about and pop 1 facet off initial, then move forward to the leading or bottom and the circumstance ought to snap appropriate off.
Dislodging the Battery
? Employing a soft device gently pry up on the battery from the edge proven. It's held on with some adhesive so You will have to perform close to the facet as properly.
? When it really is loose you need to be ready to flip the battery out but be mindful since it's nevertheless soldered to the logic board.
? If you happen to be changing the battery you can possibly use the soldering approach or the twisting strategy. These might be coated in separate manuals in the potential. For now depart the battery connected.
Eliminating the Logic Board
? There are 4 screws to get rid of as proven with the Red arrows in the photo previously mentioned. These may possibly be coated with tape. Be watchful not to strip the screws.
Free of charge Logic Board From Clips
? Be positive to use a flat screwdriver to loosen the logic board from the 4 clips demonstrated previously mentioned so You'll have a lot more area to operate with just before you move forward to the following action.
Taking away the ClickWheel Ribbon
? We have identified the top way is to Maintain the Nano among your thumb and 1st 2 fingers. You would not have a lot place to operate but it is sufficient to get a tiny flat head screwdriver in there and elevate the clip up.
? The ribbon is held in place by a connector on the logic board (see up coming phase.)
? The black latch requirements to be flipped to the up place as demonstrated previously mentioned and then the cable can be effortlessly eliminated. If you are keeping it like demonstrated flip the latch in the direction of your thumb.
Additional photo of ClickWheel Connector referenced previously mentioned
Taking away the LCD
? The LCD is eliminated in the exact same way as the ClickWheel. Be confident not to harm the black clips.
? The black clips are a bit tougher to snap back again into place than they are to snap up, so we suggest Making use of a flat instrument so as to not place as well a lot stress on any 1 point of the black clip.
LCD is Now No cost
Operate in reverse order to set up the Needed part you Require. If you have inquiries experience No cost to make contact with us at customerservice@ipodrepairsquad.com or one-888-IPOD-Resolve
No comments:
Post a Comment